trailer truck passing on road near rail guard

The mobile operating room is designed according to customer requests and consists of four sections: Technical Materials, Operating Room, Sterilization, and Intensive Care Rooms. All room floors are covered with antibacterial, waterproof, and washable materials. The room walls are reinforced with iron profiles and coated with an aluminum-PVC-based material. There is a wastewater tank and a clean water tank, with hot and cold water installations directed to the relevant rooms. The vehicle is equipped with a hospital-grade HEPA filter air conditioning system and a heating system in all rooms, a lift system for the disabled at the rear entrance of the vehicle, a special lighting system with night and day modes in the rooms, motion-sensor and password-protected doors between rooms, an inter-room communication system and internet connection, exterior lighting projectors, external 220-volt electrical input and internet input sockets, a technical room, a generator system with a 30KVA capacity, an electrical control panel and fuse boxes, medical gas cylinders and a gas station, and technical material cabinets. There is also a sterilization sink system for personnel and a sterilizer for medical instruments.

Trailler Operating Theatre

Trailler Mammography Vehicle

The Mobile Mammography Screening Vehicle, designed for the early diagnosis of breast cancer, is a specially designed trailer with a spacious interior divided into six sections. It includes a patient registration room, an examination room, a mammography screening room, a resting room, a toilet-bathroom, and a technical room. The room with state-of-the-art digital mammography equipment is surrounded by lead-coated walls. There is a workstation area set up for preliminary examinations and instant diagnosis of the mammograms taken, an intelligent control panel programmed with an automation system, and a resting room with a kitchen design for the healthcare personnel to relax during long journeys. The trailer features a special lift system for the disabled located at the rear, and a sliding, easy-to-setup staircase at the central entrance. It has an ergonomic heating and cooling system, air curtains at the door entrances, clean and wastewater tanks, hot water, and toilet and bathroom facilities. Additionally, there is a heat and water-resistant non-flammable awning outside the vehicle.

The mobile healthcare vehicle is designed as three separate work areas: passenger compartment, examination compartment, and observation compartment. The floor, ceiling, side panel coverings, and cabinets are made from special materials suitable for mobile vehicle modification. Medical devices and materials are designed and fixed in place according to their intended use. In the passenger compartment, there are seats for the driver and 5 staff members to travel. This section also includes a desk for patient records and a TV. In the examination compartment, there are a refrigerator, cabinets, an examination table that can be used for gynecological purposes, a defibrillator, ECG, monitor devices, and an overhead surgical lamp. The observation compartment, located at the rear of the vehicle, is arranged to accommodate 3 patients, with one bed designed to be suitable for X-ray imaging.

Mobile Health Bus

Mobile Laboratory Vehicle

The custom-designed mobile healthcare screening vehicle is tailored according to customer requirements. The room walls are covered with sound and heat insulating materials. Foam board material is used to make cabinets, desks, and drawers in appropriate areas within the rooms. The vehicle features an independent heating system and an independent air conditioning system in all rooms. The entire vehicle floor is covered with waterproof, antibacterial material. It includes an automatic, hydraulic stabilization and leveling system that operates when the vehicle is parked. There is a telephone system to facilitate communication between rooms. The vehicle is equipped with 220-volt electrical and internet input sockets and extension cables for external connections. Clean and wastewater tanks and plumbing systems are installed. The vehicle has passenger seats and resting areas for the personnel, anti-vibration and acid-resistant laboratory benches, a tabletop ventilation system, and sink systems with accessories. In the laboratory section, there are devices and equipment such as a pure water device, blood count device, urine analysis device, incubator, centrifuge, microscope, refrigerator, and various laboratory materials. Additionally, it includes an examination table and equipment for patients, as well as a lift system for disabled patients.

Mobile Screening Vehicle

The custom-designed mobile healthcare screening vehicle is tailored according to customer requirements. The room walls are covered with sound and heat insulating materials. Foam board material is used for cabinets, desks, and drawers in appropriate areas within the rooms. The vehicle features an independent heating system and an independent air conditioning system in all rooms. The entire vehicle floor is covered with waterproof, antibacterial material. The vehicle includes an automatic, hydraulic stabilization and leveling system that operates when the vehicle is parked, a telephone system to facilitate communication between rooms, and input sockets and extension cables providing 220-volt electricity and internet connection from outside. Clean and wastewater tanks and plumbing systems are installed. There are passenger seats and resting areas for the personnel. The X-ray room walls are coated with lead according to international (ILO) standards, and there is a floor ventilation extractor.

Mobile Hearing Screening Vehicle

The custom-designed mobile healthcare screening vehicle is tailored according to customer requirements. The room walls are covered with sound and heat insulating materials. Foam board material is used for cabinets, desks, and drawers in appropriate areas within the rooms. The vehicle features an independent heating system and an independent air conditioning system in all rooms. The vehicle includes an automatic, hydraulic stabilization and leveling system that operates when the vehicle is parked, a telephone system to facilitate communication between rooms, and input sockets and extension cables providing 220-volt electricity and internet connection from outside. There are passenger seats and resting areas for the personnel. Additionally, the vehicle includes a hearing cabin (silent room), an audiometry device, and extra sound insulation for the hearing examination room. There is also an examination table and equipment for patients, as well as a lift system for disabled patients.

Enclosed Mobile Health Vehicle

These are 4x4 chassis mobile healthcare vehicles designed to provide essential health services on-site in regions where transportation difficulties are experienced. The vehicles are equipped with the necessary equipment and devices to deliver preventive health services, outpatient diagnosis and treatment, family planning and maternal-child health education, screening for infectious diseases, and services for those with chronic illnesses.The vehicle uses a 220V installation to utilize city power grids. Additionally, in areas without access to the city grid, energy is supplied by a generator on the vehicle. The vehicle is equipped with the necessary equipment for basic gynecological interventions, including a gynecological examination table, sterilizer, centrifuge, and microscope. It also has educational equipment such as an LCD projector, laptop, LCD television, and radio CD player to facilitate training on maternal-child health and family planning. Furthermore, the vehicle is equipped with the necessary tools to provide diagnostic and treatment services.

Enclosed Mammography Vehicle

The vehicle consists of two compartments: a screening room and a waiting room. The side panels of the mammography screening room are manufactured as a single piece by injecting polyurethane under pressure between 80 mm thick, 0.55 mm surface steel sheets. The side walls of the screening room are covered with 1.5 mm thick lead plates.The side panels of the waiting room and the roof of the vehicle are also manufactured as a single piece by injecting polyurethane under pressure between 50 mm thick, 0.55 mm surface steel sheets.The passage between the screening room and the waiting room is provided by a sliding door, which includes a 1.5 mm thick lead plate. The floor of the vehicle is covered with an antibacterial, antistatic, washable, and non-slip coating. The vehicle is equipped with a sink, a wastewater tank, and a clean water tank. Additionally, an air curtain is installed at the vehicle entrance.

Enclosed Intensive Care and Operating Theatre Vehicle

These are vehicles equipped to provide rapid initial intervention to patients in emergency situations such as natural disasters. They are equipped with the necessary tools and equipment to perform basic general surgical interventions. The vehicle includes equipment such as an operating table, anesthesia machine, oxygen and suction system consisting of oxygen, nitrogen, and compressed gas, surgical aspirator, and operating room lamp. The vehicle is equipped with a 220V AC city power grid electricity and a 12V DC electricity system. In situations where external electricity is not available, there is a 7.5kW generator to meet the power needs. The interior of the vehicle features cabinet systems with sufficient compartments for medical equipment and devices. The cabinets are made of PVC-based Foamboard material, which is waterproof and antibacterial, allowing for cleaning and disinfection with cleaning agents.

Gynecology Vehicle

This is a mobile healthcare vehicle equipped with the necessary devices to conduct pre-hospital and clinic gynecological examinations and checks. It operates with city power grid electricity and a generator. The vehicle is equipped with a hot/cold air conditioner that operates on 220V city electricity.It includes a gynecological examination table and an ultrasonography (USG) device. The vehicle features cabinets made of hygienic foamboard material with sufficient compartments for the devices used, as well as bedside tables with drawers.Inside the vehicle, there are fluorescent and spotlight lamps operating on both 220V AC and 12V DC, providing adequate lighting. There is also a siren/announcement device for audible alerts and control of the roof lamps. The side and roof coverings are made of antibacterial and hygienic ABS material. The floor is covered with epoxy material. Additionally, there is a powerful rear cabin heater with room thermostat control.

Mobile Health Minibus

This is a healthcare vehicle consisting of three compartments: driver and passenger, laboratory and toilet, and examination room. It includes all devices that can be used in a laboratory, from centrifuge to sterilizer, refrigerator to microscope. In the laboratory compartment, there is a mobile vehicle-type special toilet system housed in a separate cabin. It contains examination equipment such as a table that can be used for gynecological purposes, examination lamp, defibrillator, emergency resuscitation kit, and similar emergency intervention equipment. There are passenger seats for five personnel along with the driver. The floor covering is antibacterial, washable, and non-slip. The side panels and ceiling are made of PVC-coated aluminum material after the special insulation and support bars are constructed. The vehicle is equipped with a 6.5 kW generator (capacity can be increased according to demand), and an internal lighting system consisting of 24V and 220V fixtures and spotlights.